A selection of E3D stepper motors suitable for 3D printer motion systems and extruders. All motors are supplied with a 1m motor cable.

Geared motor

This motor uses a planetary gearbox with a 5.18:1 reduction. This gives you up to 196Ncm of torque without the need for high current stepper drivers, however, you will not be able to run this motor as fast as an un-geared one. The main application of this motor is in direct extruders.

Super Whopper motor

The Super Whopper is for when you need extra power, and when motor mass is not an issue. Best used when you want a fast accelerating axis where the motor is static.

High Torque motor

A good all-around workhorse, primarily used for driving printer axes.

Compact But Powerful motor

The Compact But Powerful motor is the recommended motor for The E3D Titan and Titan Aero. It’s lighter and shorter than a typical NEMA17 motor - however, it produces almost as much torque. It is suitable for driving geared or direct extruders. It is also suitable for printer axes, provided they are light-duty, eg: a dual lead screw Z-axis that uses 2 motors.

Slimline motor

The Slimline motor is currently our lightest motor with a stepping angle of 0.9°. It’s perfect for low load applications. Supplied with a 1m motor cable, It can be used with our Titan or Titan Aero extruder.

⚠️ WARNING: This product can expose you to chemicals including Mineral Oils, which is known to the State of California to cause cancer, and Lead and Nickel, which are known to the State of California to cause cancer and birth defects or other reproductive harm.

Customer Reviews

Based on 8 reviews Write a review

Great motor

Great motor!
Please line out for the Amperage if PEAK or RMS…
Thanks!

quality motors

I got 2 super whoopers and 4 high torque motors when they were on sale for my custom corexy printer and they have worked flawlessly. I love the high current so I don't have to worry about skipping steps as much. They come with 1m cables which work, but the sleeve on the cable looks cheap, but that's not a big deal whatsoever as you probably will never see the cables once installed.

Hi Alexander,

Awesome stuff, glad to hear the motors are working flawlessly.

Georgia

Good for lower speeds.

I used it with a bondtech extruder 3:1 gear ratio and it under extruded. I just think it does not have enough power. I can't believe E3D won't publish the torque. I thought they were very proud of their product engineering. It may have been my fault. But without a torque rating I'm disappointed.

These work very well

These work very well. The shaft has a D-cut (not very obvious).

Double the quality of stock motor

This isn't promoted highly enough but more than likely this is double the quality of your supplied motor - bought with the Titan extruder and was knocked out by the increase in quality - basically this upgraded my modest CR10 mini 3D printer to a quality level close to my Prusa mk3 (which cost 2.5 times the price). Definitely consider swapping your stock motor for this one if you already have a high quality extruder.

1 2

Your cart is empty

Your cart

Subtotal

E3D Stepper Motors