Revo High Temperature Hotside Datasheet

DATASHEET

Be aware of your electronics. Please don't work on your printer while it's turned on. We advise disconnecting from the mains during installation and maintenance.
During use and cooldown, there is a potential to burn your hands.
Please read and make sure you understand the firmware requirements before attempting to print.
Please check that the components' voltage matches your printer's voltage. Double-check the polarity of connections where appropriate.
Your HotEnd and printer are your responsibility. We cannot be held responsible for damages caused by our products use, misuse or abuse.
The Revo High Temperature Hotside must be kept clean to reduce off-gassing. It's advised that gloves are worn when handling.
The Revo High Temperature Hotside is intended for polymers with high processing temperatures. Low-temperature polymers such as PLA or ABS can cause fumes if processed incorrectly.
Similar filaments may differ in specific polymer compositions. Always refer to the filament manufacturers' material datasheets for printing guidelines.
Do not overvolt the fan or heater cartridge.
E3D parts are intended for indoor use only, we cannot be responsible for issues caused through the operation of our products outside.